Trojan TS-35 35-Inch Sawhorse Legs for One Complete Sawhorse
Trojan TS-35 35-Inch Sawhorse Legs for One Complete Sawhorse
Trojan TS35 (35″ to the top of a 2×4) 35-inch leg sections for Trojan’s TWC-35 work center. Tall Sawhorse, Gripping teeth – set up requires no screws or nails, Strongest, toughest, most rugged sawhorses on the market
Trojan TS-35 35-Inch Sawhorse Legs for One Complete Sawhorse Review
Our remodeling company recently bought a set of these saw horse legs because they’re easy to transport, fast to set up (no nails or screws are needed), can be made as long or short as needed, and are super strong. Most of us are tall, so we used 2x6s for the cross bars to give us a more comfortable working height than typical horses offer. We like to use 52 inch long 2x6s for the cross bars to give us a little extra support beyond the 49 inch width of MDF sheets.
Here’s an example of how strong these saw horses are. We took two saw horses and covered them with a row of 4 foot long TJI scraps laid flat. On top of the TJIs we laid a 4 foot by 4 foot piece of ¾ inch OSB. That made a table about the same height as the back of a flat bed delivery truck. The truck was going to deliver 36 bags of concrete, each weighing 90 pounds. When the truck arrived, we had it drive up to the table. One carpenter stood on top of the table while another one stood on the truck and handed the bags over to get stacked on the table. The combined weight of the concrete and carpenter ended up being about 3,420 pounds! The saw horses held up very well although we did take care not to rock the table too much with all that weight on it. We also made sure to set the saw horses up on level ground before loading them.
These saw horses are so strong and convenient to set up that we’ll probably buy more in the future. An added benefit is that they’re made in the US, so we can be sure that the makers are getting paid a fair wage.